1 Attachment(s)
Here the table cutting ½” steel plate. I am making magnet holders for lifting steel plate with two 880 pound magnets to help load the table.
I need to level the table and I will be raising the water level once I level the table. 1/2" Thermal Dynamics 60i https://youtu.be/-iMxUaujFP0 https://ecorenovator.org/forum/attac...1&d=1577980699 The 2" by 1/4 square tube will allow the magnets to be spread apart 4'. Then it will go on my forks to make it for simpler loading thick steel plate. |
Do you have to use an air dryer , on the compressed air going to the plasma cutter ?
Wyr God bless |
2 Attachment(s)
My compressor has an auto drain on a timer. I made a copper air cooler with drain valves. Then that goes into an air dryer. Then a one-gallon desiccant dryer and a motor guard filter.
3/4" rapid Air connecting it all together. https://ecorenovator.org/forum/attac...1&d=1577984629 https://ecorenovator.org/forum/attac...1&d=1577984629 The dryer the air the better the cut and the longer consumables last. I may add a air cooler at the compressor after the pump before it enters the compressor. I am going to wait to see if I think it is needed. |
How warm is the air , after it leaves the copper coil ? Winter ? Summer
Wyr God bless |
The compressor is 80 gallons Emax I just got it powered up the other day.
I don’t know the temps yet with this new setup for my plasma table. Out of the compressor is 3/4 black iron pipe. That goes to the copper. My 3/4 regulator seems to react to slow. I think I need a better one. I will be checking the temperatures. It is cold right now but summer heat I am sure I will make lots of water. |
I was thinking , if the discharge temperature gets up , you might put a box fan blowing on the copper coil ?
Wyr God bless |
1 Attachment(s)
What I see people doing is adding a transmission cooler after the pump. Set it up to use the compressor fan to draw air through it.
Kind of like this. https://ecorenovator.org/forum/attac...1&d=1578066314 I had a auto drain to do this but the one they sent me just did not work. I am sending it back today. Does anyone know a good one? |
A transmission cooler would be a good idea if it is rated for the pressure .
Wyr God bless |
3 Attachment(s)
I cut some ½” plate to build a magnet holder.
This is to help load my table. https://ecorenovator.org/forum/attac...1&d=1578339568 This is straight off the table. https://ecorenovator.org/forum/attac...1&d=1578339568 https://ecorenovator.org/forum/attac...1&d=1578339568 |
That looks like some pretty heavy stuff!
|
All times are GMT -5. The time now is 04:13 PM. |
Powered by vBulletin® Version 3.8.11
Copyright ©2000 - 2024, vBulletin Solutions Inc.
Ad Management by RedTyger