10-22-11, 07:51 AM | #11 |
Master EcoRenovator
Join Date: Mar 2009
Location: Western Wisconsin.
Posts: 913
Thanks: 127
Thanked 82 Times in 71 Posts
|
The water to air heat exchangers are supposed to work really well because of their large surface area and the fan blowing across them allows greater flexibility in placement, if your house already has forced air heat it could even be placed in the cold air return duct work, but it sounded like you just wanted to heat your basement, correct? if that is the case then something like this could be installed in a drop ceiling or built in to the wall.
|
10-22-11, 10:57 AM | #12 | |
Supreme EcoRenovator
Join Date: Mar 2009
Location: Portland, OR
Posts: 4,004
Thanks: 303
Thanked 723 Times in 534 Posts
|
Quote:
The yearly average heat for the earth where you live (at 25 foot depth) is about 50F degrees. That would imply that the '60F degree free geothermal heat' is actually coming from heating your home, going down into the earth, not up from the earth. You could extract heat from a 50F floor to heat your basement, but your floor will get pretty darn cold when you do it. But hey, why not give it a try!!? -AC_Hacker
__________________
I'm not an HVAC technician. In fact, I'm barely even a hacker... |
|
10-22-11, 01:54 PM | #13 |
Lex Parsimoniae
Join Date: Feb 2009
Location: Woburn, MA
Posts: 4,918
Thanks: 114
Thanked 250 Times in 230 Posts
|
We've discussed this before.. And it's still puzzling me.
http://ecorenovator.org/forum/geothe....html#post4322 I even injected foam under the boiler to cut down the transfer. However, I now have some new sump holes installed. (with pumps). And luckily (or not) there is cold ground water coming into the sumps. Had some rain this month. Anyways, when I checked the incoming water, it was at 61 deg F. And I'm pretty sure it's not going to get much colder than 60F. My theory is, this water is flowing downhill to my house from the north. It has to flow under the street. I believe it might be picking up some heat from the sewer main pipes (and perhaps a little from the water main pipes). The sewer main is about 30 feet (and about 16 feet down) from my foundation. The water in sewer mains is being used in Europe as a heat source for heating. So, the same effect might be heating my basement.. Edit: Now that I think about it, if the water is flowing downhill, just a few feet under the pavement, there is the possibility of some slight solar heating of soil under the roadway and the water it's carrying. Last edited by Xringer; 10-22-11 at 04:58 PM.. Reason: Brainstorming |
10-22-11, 05:54 PM | #14 |
Supreme EcoRenovator
Join Date: Mar 2009
Location: Portland, OR
Posts: 4,004
Thanks: 303
Thanked 723 Times in 534 Posts
|
It would be very useful for you to measure and graph the temp of the water coming into your sumps, on a weekly basis.
As you can see from this chart, there is a temperature lag, depending on depth... the deeper, the greater the lag. As you can see, on the chart, the yearly average is 62F, so this particular chart is for North Carolina or similar. But for you, the natural temperature of the earth will be around 50 degrees... but the temp swings will have about the same timing, and about the same departure from the center-line. If it doesn't get colder than 60F, you probably have something else going on... my guess is that the whole thing is a result of your home heat penetrating down into the ground. Just out of curiosity, what is the temperature of your cold water, after it has run for maybe three or four minutes? -AC_Hacker
__________________
I'm not an HVAC technician. In fact, I'm barely even a hacker... Last edited by AC_Hacker; 10-22-11 at 06:09 PM.. |
10-22-11, 07:54 PM | #15 |
Lex Parsimoniae
Join Date: Feb 2009
Location: Woburn, MA
Posts: 4,918
Thanks: 114
Thanked 250 Times in 230 Posts
|
What lies beneath?
Ran the water. After about 8-10 minutes, it's at ~63 degrees F.
(62.8 on one sensor & 63.2 on the other). I have a feeling that it might be due to a large thorium deposit, since we are sitting in an area that seems to be surrounded by granite. UMass Amherst Office of News & Information : News Releases : UMass Amherst and Connecticut Geologists Position New England for Success in the Geothermal Power Era We have some extremely large (the size of small cars) granite boulders in the back yard. I think these came down with a glacier and couldn't make it up the hill.. The problem is, these are partly sunken into the ground. But have not sunk any deeper since 1973.. And they should have! There is a swamp about 15 feet north of them! With running water on the surface almost all year round. The ground back there is like mush.Those rocks should be gone.. But, it seems like there is something very solid underneath them.. So, there might be a large granite formation, or bedrock very near the surface. The house to the west of me (about 45 feet away) was built on slightly higher ground. But, their ground floor looks MUCH higher, since their basement pit, was never dug.. Their basement floor is right at ground level. Back in 1956, the people digging out all the basements on this street, gave up on the one next door.. I would not be at all surprised to find out there was a solid granite hill top just a few feet under our basement floor slab.. NH, aka the Granite State is actually the Radioactive Granite State. As they found out back in 1962.. http://www.ncbi.nlm.nih.gov/pmc/arti.../pnas00234-002 http://gsa.confex.com/gsa/2011AM/fin...act_197051.htm Last edited by Xringer; 10-22-11 at 09:50 PM.. Reason: Hot rocks! |
10-23-11, 09:51 AM | #16 |
Lex Parsimoniae
Join Date: Feb 2009
Location: Woburn, MA
Posts: 4,918
Thanks: 114
Thanked 250 Times in 230 Posts
|
This radioactive stuff is creeping me out. Time to check the Radon gas at the new sump holes.
If it goes over 5 or 6 ppm, I'm going to need to add some ventilation to the basement. |
11-08-11, 06:57 PM | #17 |
Lex Parsimoniae
Join Date: Feb 2009
Location: Woburn, MA
Posts: 4,918
Thanks: 114
Thanked 250 Times in 230 Posts
|
Radon gas was only 2 ppm.. (Normal in my house), so I've moved the sensor to another new sump hole.
It takes a couple of weeks to get a good reading. I've been watching the temperature in the sumps, which are pretty dry today. On average, the three deep holes are showing 56.2F this week. Got the same 56.2 temp on the floor (surface) at the far end of the house, from the hot-water boiler.. Tap water is now at 55.7F and I'll be interested to see what happens after we get water in the sumps again.. Maybe higher ground water levels will increase the basement temps? Or, maybe as the winter wears on, it will drop down to the low 50s.?.
__________________
My hobby is installing & trying to repair mini-splits EPA 608 Type 1 Technician Certification ~ 5 lbs or less.. |
11-09-11, 10:25 AM | #18 |
Apprentice EcoRenovator
Join Date: Feb 2011
Location: Driftless Region, North America, Earth, Solar System, Orion Arm, Milky Way Galaxy,Virgo Supercluster
Posts: 116
Thanks: 13
Thanked 35 Times in 25 Posts
|
Personally I like active air systems due to their simplicity and reliability. An air leak is much less of an issue than a water leak. An aluminum screen collector is dead simple and cheap compared to a hydronic system. Considering the sheer amount of btus required for space heating, IMO forced air is a better solution. Forget complicated heat storage (except maybe some thermal mass in the living space where you can incorporate it), and just try to offset your fuel use as much as possible. Why use the "higher quality heat" of hydronic system when a higher volume of "lower quality heat" from an active air system gets the job done just as well? Being more economical will allow you to maximize your collector area. Just my $0.02
|
11-09-11, 01:11 PM | #19 |
Lex Parsimoniae
Join Date: Feb 2009
Location: Woburn, MA
Posts: 4,918
Thanks: 114
Thanked 250 Times in 230 Posts
|
Yeah, I think you are right.. If I didn't have to deal with the bush in front of the house,
I would love to have a basement heater like this one.. That miniature tree doesn't really do anything. Just for looks.. Maybe when I get some new replacement windows for the Den, I can build a 16'x4' hot-air collector out of the old Andersen sliders.. Or, maybe put two 4'x'8' collectors on either side of the special plant..?.
__________________
My hobby is installing & trying to repair mini-splits EPA 608 Type 1 Technician Certification ~ 5 lbs or less.. |
11-10-11, 10:21 AM | #20 | |
Helper EcoRenovator
Join Date: Jan 2010
Location: Little Rock, AR
Posts: 95
Thanks: 16
Thanked 13 Times in 12 Posts
|
Quote:
If moving it isn't an option, you could build a raised bed around the front of your house and have the solar collector on the front of that bed. That would involve some more complicated duct work, but it may mean you are able to have your solar collector and keep the bush . |
|
|
|