|06-25-18, 09:49 PM||#1|
Join Date: Nov 2012
Thanked 125 Times in 105 Posts
Diy solar install
So day marks the beginning of my solar install.
Step 1, up grade by adding a new 125 amp square d QO outdoor panel and remove as much inappropriate wiring as possible.
The thorn in my foot is the 6/2 with ground UF-B wire running out to my solar panel area back to the main panel.
It's on a tandem breaker which means the neutral and ground were running on the bare wire.
Not good, never would have come any where close to passing inspection like that.
I think what I will end up doing is reusing this wire to run a 240 welder circuit out to my solar panel and animal pen area then run conduit and run new proper wire out there.
I have pics but I will need to resize them or take new ones with my digital camera.
|diy, garage, heat pump, inverter, solar|