|
01-02-20, 09:52 AM
|
#15 |
|
Super Moderator
Join Date: Jun 2013
Location: SC
Posts: 2,933
Thanks: 172
Thanked 564 Times in 463 Posts
|
Here the table cutting ½” steel plate. I am making magnet holders for lifting steel plate with two 880 pound magnets to help load the table.
I need to level the table and I will be raising the water level once I level the table. 1/2" Thermal Dynamics 60i https://youtu.be/-iMxUaujFP0 The 2" by 1/4 square tube will allow the magnets to be spread apart 4'. Then it will go on my forks to make it for simpler loading thick steel plate.
__________________
Current project Aquaponics system , Passive Solar Greenhouse build To view links or images in signatures your post count must be 0 or greater. You currently have 0 posts. Solar Install 12.5 Kwh- To view links or images in signatures your post count must be 0 or greater. You currently have 0 posts. Mini Split installs - To view links or images in signatures your post count must be 0 or greater. You currently have 0 posts. EV Chevy Volt - To view links or images in signatures your post count must be 0 or greater. You currently have 0 posts. |
|
|
| The Following User Says Thank You to pinballlooking For This Useful Post: | Daox  (01-02-20) |
| Thread Tools | |
| Display Modes | |
|
|
Threaded Mode