|
07-08-19, 10:51 AM
|
#1 |
|
Super Moderator
Join Date: Jun 2013
Location: SC
Posts: 2,923
Thanks: 172
Thanked 564 Times in 463 Posts
|
I ordered a 4x4 CNC plasma table
I did a fair amount of research looking at build /buy a CNC table. I was close to making one but in the end buying just made more since.
I would have had more money in building one. I have a lot to learn just in software to use it. It will be about 8 weeks before I get it. They build to order and they just had a sale. I am getting a water table to keep smoke down and warping to a Min. It has torch height control. I will be using my new plasma cutter on it. I will have to buy a CNC port board and a machine torch. Delusional Designs https://www.delusionaldesignscnc.com...ter_Table.html I am not sure where our focus will be yet. I will be selling some stuff I cut but I would like to keep the finish and painting part to not much as this is a side business. I am probably limited to ½” and under cuts. I will add an extension to the table to all put a 4’x8’ sheet on the table. If we like doing this we will buy a table extension to expand this table to 4’x8’ table.
__________________
Current project Aquaponics system , Passive Solar Greenhouse build To view links or images in signatures your post count must be 0 or greater. You currently have 0 posts. Solar Install 12.5 Kwh- To view links or images in signatures your post count must be 0 or greater. You currently have 0 posts. Mini Split installs - To view links or images in signatures your post count must be 0 or greater. You currently have 0 posts. EV Chevy Volt - To view links or images in signatures your post count must be 0 or greater. You currently have 0 posts. Last edited by pinballlooking; 07-09-19 at 08:33 AM.. |
|
|
| The Following User Says Thank You to pinballlooking For This Useful Post: | Fordguy64 (07-09-19) |
| Thread Tools | |
| Display Modes | |
|
|
Threaded Mode