Ac Coupled Dump Load

nokiasixteth · 10-23-21, 05:42 PM

So after playing with settings with the solar edge and critical loads panel the Schneider sw 4048 does frequency shift and the solar edge drops the output. This is fine and works . But right now i have a smallish battery bank of 48 volt 133 ah. I am trying to figure out what would be the easiest way to make the system so it keeps using the power as it comes in from solar to a water heater . As the water heater uses the most of my energy consumption here. Has anyone done a Ac coupled dump load per say ? Obviously past experience is better than my calculation on paper thoughts.

NiHaoMike · 10-24-21, 06:41 PM

Add a SSR to switch the water heater, then use an Arduino to control it based on the water temperature and battery voltage.

nokiasixteth · 11-08-21, 06:03 PM

Quote:

Originally Posted by NiHaoMike

Add a SSR to switch the water heater, then use an Arduino to control it based on the water temperature and battery voltage.

Thanks . I will add that to heat the pool up as secondary first will preheat the water going to the water heater

10-23-21, 05:42 PM	#1
nokiasixteth Journeyman EcoRenovator Join Date: Jan 2014 Location: Earth Posts: 348 Thanks: 43 Thanked 14 Times in 13 Posts	Ac Coupled Dump Load So after playing with settings with the solar edge and critical loads panel the Schneider sw 4048 does frequency shift and the solar edge drops the output. This is fine and works . But right now i have a smallish battery bank of 48 volt 133 ah. I am trying to figure out what would be the easiest way to make the system so it keeps using the power as it comes in from solar to a water heater . As the water heater uses the most of my energy consumption here. Has anyone done a Ac coupled dump load per say ? Obviously past experience is better than my calculation on paper thoughts.

10-24-21, 06:41 PM	#2
NiHaoMike Supreme EcoRenovator Join Date: Oct 2008 Location: Austin, TX Posts: 1,154 Thanks: 14 Thanked 257 Times in 241 Posts	Add a SSR to switch the water heater, then use an Arduino to control it based on the water temperature and battery voltage. __________________ To my surprise, shortly after Naomi Wu gave me a bit of fame for making good use of solar power, Allie Moore got really jealous of her...