Sanyo 24KHS72 AC/HP DIY install project

Xringer · 10-04-09, 09:59 PM

Is this gauge any good?

Gauge 2" Vacuum Gauge 0-30"HG (0to -1 BAR) 1/8 NPT - eBay (item 180406066600 end time Oct-09-09 16:45:04 PDT)

Hey, owning a vacuum pump might be useful for other stuff too.
And, like you said, I can always sell it..

I just read the manual for the AC only unit (borrowed from work) and it
said to vacuum down the lines to 10 mmHg abs, shut off the pump,
then release some R410A into the lines (for 10 seconds), shut it off
and then do a soap bubble test on all the fittings..

That seems simple enough. Hey, that's the same as the AC/HP model too!

Did you use Ester Oil on the fittings before torquing them?

Thread Tools
Show Printable Version Email this Page
Display Modes
Switch to Linear Mode Switch to Hybrid Mode Threaded Mode

10-04-09, 09:59 PM	#11
Xringer Lex Parsimoniae Join Date: Feb 2009 Location: Woburn, MA Posts: 4,918 Thanks: 114 Thanked 250 Times in 230 Posts	Is this gauge any good? Gauge 2" Vacuum Gauge 0-30"HG (0to -1 BAR) 1/8 NPT - eBay (item 180406066600 end time Oct-09-09 16:45:04 PDT) Hey, owning a vacuum pump might be useful for other stuff too. And, like you said, I can always sell it.. I just read the manual for the AC only unit (borrowed from work) and it said to vacuum down the lines to 10 mmHg abs, shut off the pump, then release some R410A into the lines (for 10 seconds), shut it off and then do a soap bubble test on all the fittings.. That seems simple enough. Hey, that's the same as the AC/HP model too! Did you use Ester Oil on the fittings before torquing them?