Sanyo 24KHS72 AC/HP DIY install project

Xringer · 11-03-09, 02:17 PM

Made from 1.25" PVC. Some very strong stuff.. Unless you don't glue it..

The plan is to cover the top with some white PALRUF
PALRUF® - Corrugated PVC Sheet
I have one sheet, but need to pick up one more and some of their mounting gizmos.

White Sidewalls:
I'm considering placing 24"x44" panels of plastic (siding or corplas), down
low on each side, to keep the snow drifts from drifting into the sides..

Any suggestions?

After I figure out where I want the feet to rest, I'll drive some square steel
'rods' into the ground, and the 'legs' will slip over the steel..
Hopefully, keeping the wind from taking the whole thing out to US-95,
where it would be hit by a 16 wheeler!

11-03-09, 02:17 PM	#11
Xringer Lex Parsimoniae Join Date: Feb 2009 Location: Woburn, MA Posts: 4,918 Thanks: 114 Thanked 250 Times in 230 Posts	Snow Roof frame work Made from 1.25" PVC. Some very strong stuff.. Unless you don't glue it.. The plan is to cover the top with some white PALRUF PALRUF® - Corrugated PVC Sheet I have one sheet, but need to pick up one more and some of their mounting gizmos. White Sidewalls: I'm considering placing 24"x44" panels of plastic (siding or corplas), down low on each side, to keep the snow drifts from drifting into the sides.. Any suggestions? After I figure out where I want the feet to rest, I'll drive some square steel 'rods' into the ground, and the 'legs' will slip over the steel.. Hopefully, keeping the wind from taking the whole thing out to US-95, where it would be hit by a 16 wheeler!