EcoRenovator  

Go Back   EcoRenovator > Improvements > Geothermal & Heat Pumps
Advanced Search
 


Blog 60+ Home Energy Saving Tips Recent Posts Search Today's Posts Mark Forums Read


Reply
 
Thread Tools Display Modes
Old 03-03-15, 08:55 AM   #1
theoldwizard1
Apprentice EcoRenovator
 
Join Date: Oct 2014
Location: SE MI
Posts: 105
Thanks: 3
Thanked 12 Times in 9 Posts
Default How deep does non-permafrost typically go ?

Areas like the U.P. of MI, northern MN, ME, ND and most of Canada get deep frost, at last 48". These areas obviously warm up enough in summer so that the ground (eventually) does melt.

Are deep vertical wells a reasonable source of "heat" for geothermal heat pumps ?

Most vertical GSHP don't see "stabilized" temperatures until at least 20'. For these colder climates, I suspect that is more like 40-50'. If the pipes are well insulated from that depth all the way to the heat pump, would that be adequate ?

theoldwizard1 is offline   Reply With Quote
Old 03-03-15, 07:04 PM   #2
AC_Hacker
Supreme EcoRenovator
 
AC_Hacker's Avatar
 
Join Date: Mar 2009
Location: Portland, OR
Posts: 4,004
Thanks: 303
Thanked 723 Times in 534 Posts
Default

Quote:
Originally Posted by theoldwizard1 View Post
Areas like the U.P. of MI, northern MN, ME, ND and most of Canada get deep frost, at last 48". These areas obviously warm up enough in summer so that the ground (eventually) does melt.

Are deep vertical wells a reasonable source of "heat" for geothermal heat pumps ?

Most vertical GSHP don't see "stabilized" temperatures until at least 20'. For these colder climates, I suspect that is more like 40-50'. If the pipes are well insulated from that depth all the way to the heat pump, would that be adequate ?
These are very good questions.

You should consult some local GSHP installers, they would have exactly the information you are looking for.

I doubt that anyone on this forum actually has this information.

I hope that when you find out, you'll let us know.

Best,

-AC_Hacker
__________________
I'm not an HVAC technician. In fact, I'm barely even a hacker...
AC_Hacker is offline   Reply With Quote
Old 03-03-15, 07:06 PM   #3
theoldwizard1
Apprentice EcoRenovator
 
Join Date: Oct 2014
Location: SE MI
Posts: 105
Thanks: 3
Thanked 12 Times in 9 Posts
Default

Quote:
Originally Posted by AC_Hacker View Post
These are very good questions.
Sigh. My life's story !

It usually takes a lot of digging on my part !!
theoldwizard1 is offline   Reply With Quote
Old 03-04-15, 12:24 AM   #4
AC_Hacker
Supreme EcoRenovator
 
AC_Hacker's Avatar
 
Join Date: Mar 2009
Location: Portland, OR
Posts: 4,004
Thanks: 303
Thanked 723 Times in 534 Posts
Default

Quote:
Originally Posted by theoldwizard1 View Post
Sigh. My life's story ! It usually takes a lot of digging on my part !!
Yeah, but permafrost does not apply to that kind of digging.

-AC
__________________
I'm not an HVAC technician. In fact, I'm barely even a hacker...
AC_Hacker is offline   Reply With Quote
Old 03-04-15, 05:40 AM   #5
Mikesolar
Master EcoRenovator
 
Mikesolar's Avatar
 
Join Date: Aug 2012
Location: Toronto
Posts: 958
Thanks: 40
Thanked 158 Times in 150 Posts
Default

I remember one particularly bad year back in 93 (I think) when the weather was cold enough that the water lines 7ft down were freezing. That is rare but I don't remember ever hearing of building footings having an issue at 4ft. I would guess that you would have stable temps from 10' down or at least no possibility of freezing. Thing is, you have 500ft of tubing in one hole so the 10ft or so at the top won't affect the output much.

That number will be different in the far north tho. The number may be 20ft.
Mikesolar is offline   Reply With Quote
Old 03-04-15, 07:33 AM   #6
theoldwizard1
Apprentice EcoRenovator
 
Join Date: Oct 2014
Location: SE MI
Posts: 105
Thanks: 3
Thanked 12 Times in 9 Posts
Default

Quote:
Originally Posted by AC_Hacker View Post
Yeah, but permafrost does not apply to that kind of digging.

-AC
Well, I did learn that permafrost is REALLY PERMANENT ! It can actually go 100s of feet deep !
theoldwizard1 is offline   Reply With Quote
Old 03-04-15, 07:37 AM   #7
theoldwizard1
Apprentice EcoRenovator
 
Join Date: Oct 2014
Location: SE MI
Posts: 105
Thanks: 3
Thanked 12 Times in 9 Posts
Default

Quote:
Originally Posted by Mikesolar View Post
I would guess that you would have stable temps from 10' down or at least no possibility of freezing.
.
.
.
That number will be different in the far north tho. The number may be 20ft.
I was reading on another forum about folks who had installed horizontal loops at 12-15' deep, actually getting inlet water from their loop well below freezing ! Sure, it has been cold in the Midwest USA, with temps below 0F, but if your inlet water temp is below freezing, IMHO, you have a SERIOUS design/installation flaw !
theoldwizard1 is offline   Reply With Quote
Old 03-05-15, 05:31 AM   #8
Mikesolar
Master EcoRenovator
 
Mikesolar's Avatar
 
Join Date: Aug 2012
Location: Toronto
Posts: 958
Thanks: 40
Thanked 158 Times in 150 Posts
Default

Quote:
Originally Posted by theoldwizard1 View Post
I was reading on another forum about folks who had installed horizontal loops at 12-15' deep, actually getting inlet water from their loop well below freezing ! Sure, it has been cold in the Midwest USA, with temps below 0F, but if your inlet water temp is below freezing, IMHO, you have a SERIOUS design/installation flaw !
You can still get reasonable performance from a HP when the installation temps are below freezing. Just don't let the installers skimp on tubing. Remember that and ASHP starts losing efficiency well below that.
Mikesolar is offline   Reply With Quote
Old 03-05-15, 08:14 AM   #9
theoldwizard1
Apprentice EcoRenovator
 
Join Date: Oct 2014
Location: SE MI
Posts: 105
Thanks: 3
Thanked 12 Times in 9 Posts
Default

Quote:
Originally Posted by Mikesolar View Post
You can still get reasonable performance from a HP when the installation temps are below freezing. Just don't let the installers skimp on tubing. Remember that and ASHP starts losing efficiency well below that.
If I ever had a GSHP system installed, there would be a "performance" clause in the contract. If my inlet water temp EVER fell below 40F, the installer would have to repair/replace/agument the ground loop. I would try to hold 50% of his installation fee in escrow for at least 1 year.

If you are going to pay the premium of having a GSHP, you want one that is designed and installed for optimal performance !
theoldwizard1 is offline   Reply With Quote
Old 03-05-15, 08:17 AM   #10
Mikesolar
Master EcoRenovator
 
Mikesolar's Avatar
 
Join Date: Aug 2012
Location: Toronto
Posts: 958
Thanks: 40
Thanked 158 Times in 150 Posts
Default

You wouldn't have to go that far. Lots of systems have input water temps that low and still perform well. It just has to be designed for it. No problems.

Don't forget, the system has glycol in it so it won't have a freeze problem and it won't hurt the equipment.

Mikesolar is offline   Reply With Quote
Reply


Thread Tools
Display Modes

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump


All times are GMT -5. The time now is 08:42 AM.


Powered by vBulletin® Version 3.8.11
Copyright ©2000 - 2024, vBulletin Solutions Inc.
Ad Management by RedTyger
Inactive Reminders By Icora Web Design