EcoRenovator  

Go Back   EcoRenovator > Improvements > Solar Power
Advanced Search
 


Blog 60+ Home Energy Saving Tips Recent Posts Search Today's Posts Mark Forums Read


Reply
 
Thread Tools Display Modes
Old 10-31-12, 12:22 PM   #1
Fordguy64
Journeyman EcoRenovator
 
Join Date: Oct 2011
Location: Cincinnati ohio
Posts: 338
Thanks: 40
Thanked 35 Times in 31 Posts
Default Cooling solar panels..

So while at work today I was thinking.. Going off the info of when solar panels get hot they become less efficient. That if you attached copper pipe to the back of the solar panel you could possibly heat water and cool the solar panel?? I'm not sure how hot the back of solar panels get tho? Just a thought anyone have any input? As I have not seen anyone do anything like this

Fordguy64 is offline   Reply With Quote
Old 10-31-12, 01:22 PM   #2
Xringer
Lex Parsimoniae
 
Xringer's Avatar
 
Join Date: Feb 2009
Location: Woburn, MA
Posts: 4,918
Thanks: 114
Thanked 250 Times in 230 Posts
Default

Over the last few years, I've seen a few combo panels around,
but since they are integrated into one unit, they aren't a big seller..

#1. After the company fails, you are stuck with a combo panel you can't repair. (no parts).
#2. Combo panels are costly. It might be cheaper to install two systems.
#3. Complexity means more things to go wrong.

Since the back side of my PV is hotter than the sunny side, I've wondered about cooling them,
by attaching a DIY hot water heat exchanger under the panels.

Seems like a lot of work to attach the HX units to each panel,
when I could build HW panels (or buy used HW panels) for a little more $$.

The complexity builds up if you live where it gets below 32F..
Now you need anti-freeze water, instead of tap water.
That means a double-wall HX (to meet code).


One other problem with using a closed loop system. When the storage tank water gets really hot,
Then fairly hot water is going to be pumped into the HX.
That's going to mean the PV is not going to see a lot of cooling.
So, the big PV cooling gain might not be there..
(Unless you use a bunch of hot water)..


IMHO, Not really feasible for the average DIYer..

One of the best ways to get more power out of your PV is to cut down all the trees that shade your panels..
Another way to get more juice is to make your elevation adjustable.
So you can tweak the angle to match the season..

I don't recommend a DIY solar tracker, unless you keep the PV under 500w.
Gets too complicated with big arrays..
__________________
My hobby is installing & trying to repair mini-splits
EPA 608 Type 1 Technician Certification ~ 5 lbs or less..
Xringer is offline   Reply With Quote
Old 10-31-12, 05:51 PM   #3
ecomodded
Supreme EcoRenovator
 
Join Date: Sep 2012
Location: Vancouver Island,Canada.
Posts: 1,037
Thanks: 116
Thanked 100 Times in 87 Posts
Default

How about making a solar heat panel with the back of the PV panels as heat exchangers. They could act as a pre-warmer for a Purpose built Solar heat exchanger.
ecomodded is offline   Reply With Quote
Old 10-31-12, 06:27 PM   #4
Xringer
Lex Parsimoniae
 
Xringer's Avatar
 
Join Date: Feb 2009
Location: Woburn, MA
Posts: 4,918
Thanks: 114
Thanked 250 Times in 230 Posts
Default

They do make combination panels..


Solimpeks PV-T Hybrid Collectors | SOLIMPEKS Solar Energy Corp.


They just aren't practical.. I think the warranty on this type of panel is likely
only 5 to 10 years. The standard PV panels are for 2 or 3 times as long.


This kind of "hybrid" panel isn't ready for prime time.
Kinda like the Solar Powered car.. Not practical.

__________________
My hobby is installing & trying to repair mini-splits
EPA 608 Type 1 Technician Certification ~ 5 lbs or less..
Xringer is offline   Reply With Quote
Old 10-31-12, 09:49 PM   #5
ecomodded
Supreme EcoRenovator
 
Join Date: Sep 2012
Location: Vancouver Island,Canada.
Posts: 1,037
Thanks: 116
Thanked 100 Times in 87 Posts
Default

It would be fairly easy to make a homemade shallow box to mount to the back of the PV panel. Each panel would need its own intake vent/hole , sharing a single inline fan for pulling air threw them. A big array, 2,000,3,000 or 4,000w or better would make for a serious heater. A smaller amount of PV panels could act as a pre warmer for the Solar collectors.

I am going to explore this avenue.

Last edited by ecomodded; 10-31-12 at 09:51 PM..
ecomodded is offline   Reply With Quote
Old 10-31-12, 11:48 PM   #6
Xringer
Lex Parsimoniae
 
Xringer's Avatar
 
Join Date: Feb 2009
Location: Woburn, MA
Posts: 4,918
Thanks: 114
Thanked 250 Times in 230 Posts
Default

IIRC, the backside of some of my PV was up around 120 to 150F.

You might not need to mount each panel as the lid of an air-box.
Maybe just mounting them pressed up against each other would work.
Then, you could build a little 4" wall around the outside edge of the array. One big hot air collector box!


Blow cool house air into the bottom of the array (spread it with manifold dams)
and suck heated air out the top..

Just what I need to heat my basement in the winter time..

Summer might be a problem..
__________________
My hobby is installing & trying to repair mini-splits
EPA 608 Type 1 Technician Certification ~ 5 lbs or less..
Xringer is offline   Reply With Quote
Old 11-01-12, 01:22 AM   #7
Ryland
Master EcoRenovator
 
Join Date: Mar 2009
Location: Western Wisconsin.
Posts: 913
Thanks: 127
Thanked 82 Times in 71 Posts
Default

How much is the output dropping? 10% or so on a hot day? on a 1kw system that is $200 worth of panels that are more or less being cut out of your production, as I see it you can either spend that $200 on another panel, or you can spend it on a roll of copper pipe... then another $200 on a pump, $500 on a storage tank and the list goes on and on! or you can buy another panel and get more output all of the time!
Ryland is offline   Reply With Quote
The Following User Says Thank You to Ryland For This Useful Post:
FortyTwo (11-08-12)
Old 11-01-12, 06:57 AM   #8
Xringer
Lex Parsimoniae
 
Xringer's Avatar
 
Join Date: Feb 2009
Location: Woburn, MA
Posts: 4,918
Thanks: 114
Thanked 250 Times in 230 Posts
Default

Yeah Rayland! The lowest cost way to pick up some extra power is to add more PV.
That's what the experts tell people when they start talking about trackers.

I've seen some large tracking system prices, where the tracker hardware price
was about equal to the cost of the panels.
__________________
My hobby is installing & trying to repair mini-splits
EPA 608 Type 1 Technician Certification ~ 5 lbs or less..
Xringer is offline   Reply With Quote
Old 11-01-12, 05:43 PM   #9
Fordguy64
Journeyman EcoRenovator
 
Join Date: Oct 2011
Location: Cincinnati ohio
Posts: 338
Thanks: 40
Thanked 35 Times in 31 Posts
Default

very good info guys
Fordguy64 is offline   Reply With Quote
Old 11-01-12, 09:54 PM   #10
Ryland
Master EcoRenovator
 
Join Date: Mar 2009
Location: Western Wisconsin.
Posts: 913
Thanks: 127
Thanked 82 Times in 71 Posts
Default

Right, trackers make sense when you have very limited space and need to do things like put your panels on a pole to get at the sun, at that point you might as well put them on a tracker as well.

Cooling your panels adds cost, weight, complexity and isn't going to be a great way to get hot water because the panels aren't getting hot enough, so you end up getting expensive warm water.

Ryland is offline   Reply With Quote
Reply


Thread Tools
Display Modes

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump


All times are GMT -5. The time now is 10:56 AM.


Powered by vBulletin® Version 3.8.11
Copyright ©2000 - 2024, vBulletin Solutions Inc.
Ad Management by RedTyger
Inactive Reminders By Icora Web Design