03-24-13, 02:21 PM | #1 |
Helper EcoRenovator
Join Date: Dec 2012
Location: Cave City Kentucky
Posts: 45
Thanks: 7
Thanked 7 Times in 4 Posts
|
My Harbor Freight Panels died
I was out in my shed and noticed that may battery voltage was 12.3 volts. Should have been 13 something as it was in the middle of the day. Checked each panel with a multi-meter and nothing. I don't see how all three died at once. Did have some lightning a couple of nights earlier, but no physical damage and the little charge controller was still indicating battery voltage. I did have a circular saw laying right next to the charge controller though. Maybe the magnets in the saw motor did something to the charge controller to kill the panels? Strange....
|
03-24-13, 06:08 PM | #2 |
Apprentice EcoRenovator
Join Date: Oct 2010
Location: Simcoe County, Ontario, Canada
Posts: 102
Thanks: 11
Thanked 15 Times in 10 Posts
|
Did you check each panel at the panel terminals? It almost sounds like there is a wiring problem. You mention lightning- was there rain with it? Maybe there's a connection that has gotten wet repeatedly, and enough corrosion and oxide have accumulated to finally open the circuit. Is there a fuse hidden in a connector somewhere? I can't imagine that a skilsaw sitting close by could have that much infuence. Let us know how it works out!
|
03-24-13, 06:35 PM | #3 |
Hi-Tech Hillbilly
|
Coulda got a surge. Disconnect the battery from the controller after dark for a few minutes and reconnect. Go out tomorrow and check 'um again..
Mine screws up when I key up my 2-way radio. I have a C-40 but the r.f. makes it do weird stuff..
__________________
If it don't, I'll always think it shoulda.. |
03-25-13, 10:39 PM | #4 |
Master EcoRenovator
Join Date: Mar 2009
Location: Western Wisconsin.
Posts: 913
Thanks: 127
Thanked 82 Times in 71 Posts
|
How do you know that they all died at once?
First tip off was that they are from harbor freight... On really basic set ups like it sounds like you have it's really common to have a basic amp meter as well as a volt meter so you can see how many amps you are getting off the panels, that way you can tell right away that something doesn't look right because on a clear day or whatever, you should be getting a set number of amps if all the connections are good and there aren't any issues with the panels, get to much shading or something and your numbers will start dropping quickly. |
03-28-13, 09:05 PM | #5 |
Master EcoRenovator
Join Date: Aug 2012
Location: Toronto
Posts: 958
Thanks: 40
Thanked 158 Times in 150 Posts
|
Check for diode issues.
|
04-01-13, 07:04 AM | #6 | |
Helper EcoRenovator
Join Date: Mar 2013
Location: 245862
Posts: 43
Thanks: 12
Thanked 3 Times in 3 Posts
|
Quote:
|
|
04-02-13, 09:49 PM | #7 |
Helper EcoRenovator
Join Date: Dec 2012
Location: Cave City Kentucky
Posts: 45
Thanks: 7
Thanked 7 Times in 4 Posts
|
Checked voltage at the batteries, and was 13.6 volts with the charge controller display still indicating 12.3 I probably will slave in a different meter and see what happens. Just lighting the shed and occasionally use a power tool on the 1200 watt inverter.
|
|
|