01-30-13, 02:36 PM | #27 |
Supreme EcoRenovator
|
I had the same problem last month with my project. The unit would hold pressure to about 50-75 psi, but no higher. It would eventually leak down to 10 psi or so. I eventually found the leak with the soapy water method and 60 psi from an almost empty tank of torch gas. Turned out to be a crack in a bend. I suppose at low pressure it was holding itself shut.
Hope this helps. Good luck and godspeed |
The Following User Says Thank You to jeff5may For This Useful Post: | AC_Hacker (01-30-13) |
Thread Tools | |
Display Modes | |
|
|