Need advice about Cat 6 running parallel to unshielded Romex...

AC_Hacker · 02-12-17, 07:24 PM

Anybody have any code or experiential advice about running Cat 6 Ethernet parallel to unshielded Romex?

The parallel run will be about 16 ft.

I've seen a lot of opinion but little code on such a thing.

In one UK post, citing code said to keep the runs separated by at least 2".

An opinion said they should each be metal shielded and no less than 12".

Quite a bit of variation there.

Thanks...

-AC

02-12-17, 07:24 PM	#1
AC_Hacker Supreme EcoRenovator Join Date: Mar 2009 Location: Portland, OR Posts: 4,004 Thanks: 303 Thanked 723 Times in 534 Posts	Need advice about Cat 6 running parallel to unshielded Romex... Anybody have any code or experiential advice about running Cat 6 Ethernet parallel to unshielded Romex? The parallel run will be about 16 ft. I've seen a lot of opinion but little code on such a thing. In one UK post, citing code said to keep the runs separated by at least 2". An opinion said they should each be metal shielded and no less than 12". Quite a bit of variation there. Thanks... -AC __________________ I'm not an HVAC technician. In fact, I'm barely even a hacker...

Thread Tools
Show Printable Version Email this Page
Display Modes
Switch to Linear Mode Switch to Hybrid Mode Threaded Mode