|
Advanced Search |
|
Thread Tools | Display Modes |
|
02-02-09, 08:25 PM | #1 |
Infrequent noob
Join Date: Aug 2008
Location: 1000 Islands region, Ontario, Canada
Posts: 402
Thanks: 37
Thanked 20 Times in 19 Posts
|
Link love
__________________
.
|
02-11-09, 01:38 PM | #2 |
Infrequent noob
Join Date: Aug 2008
Location: 1000 Islands region, Ontario, Canada
Posts: 402
Thanks: 37
Thanked 20 Times in 19 Posts
|
I'd consider using a cap if I was just going to output the power directly to the inverter to run a radio or the laptop while I rode the bike. It seems the inverter needs a steadier voltage than I'm able to deliver when it's drawing more than half an amp.
FYI, I've pretty much worn out the sidewall of the old tire on the bike. The plastic hub on the motor itself is wearing down too. I need to flip the tire around to get another couple of weeks out of it. By then (hopefully) the outside conditions should be less cold & icy so I can do my bike riding outside. Version 2 of this needs to be chain or belt driven, or at least run off the main tread area of the tire (a slick would be better than knobbies)
__________________
.
|
05-04-09, 10:45 PM | #3 |
Lurking Renovator
Join Date: May 2009
Posts: 1
Thanks: 0
Thanked 0 Times in 0 Posts
|
Hi,
This is a great Idea turned cheap. I love it. Can you please explain a little more about the electrical connections? I think that the generator goes connected to the battery with a switch in between, and then the power inverter goes connected to the battery (with a switch as well?). So, it seems that when you connect the battery to the generator/motor the motor will start spinning, and you only have to get on the bicycle and pedal against the motor? is that right? Also, I'm debating whether to use a car alternator or not. I am planning to go to a junker and buy a car alternator. Do you think that the car alternator would require a high (too high?) pedaling speed to work? on the other hand, what would be the best way to get a used 12 volts permanent magnet motor? Thank you, Regards, |
05-20-09, 07:53 AM | #4 | ||||
Infrequent noob
Join Date: Aug 2008
Location: 1000 Islands region, Ontario, Canada
Posts: 402
Thanks: 37
Thanked 20 Times in 19 Posts
|
Quote:
Quote:
Quote:
Watch this video. This is an unmodified car alternator, and the rider is out of breath after a minute of powering a light: Quote:
Thank you, Regards,[/quote]
__________________
.
|
||||
05-28-09, 03:37 PM | #5 |
Supreme EcoRenovator
Join Date: Oct 2008
Location: Austin, TX
Posts: 1,154
Thanks: 14
Thanked 257 Times in 241 Posts
|
http://techno-fandom.org/~hobbit/cars/boost-hack/
Maybe try that trick to get more voltage at lower speeds? I actually tried it with the motor for my hybrid bike. By turning the motor by hand (I don't have it installed yet) without the circuit, it only generates about 2v. But with the circuit, it goes up to over 200v!
__________________
To my surprise, shortly after Naomi Wu gave me a bit of fame for making good use of solar power, Allie Moore got really jealous of her... |
05-28-09, 03:43 PM | #6 |
Infrequent noob
Join Date: Aug 2008
Location: 1000 Islands region, Ontario, Canada
Posts: 402
Thanks: 37
Thanked 20 Times in 19 Posts
|
I'm not ashamed to admit that Hobbit & Lee Hart are over my head.
(You too, NiHaoMike!)
__________________
.
|
05-28-09, 10:40 PM | #7 |
Supreme EcoRenovator
Join Date: Oct 2008
Location: Austin, TX
Posts: 1,154
Thanks: 14
Thanked 257 Times in 241 Posts
|
It really has to do with Faraday's Law and Lenz's Law. The voltage induced in a coil of wire is proportional to the rate of change of magnetic flux, which is proportional to the speed of the generator shaft. Therefore, at low speeds, the generator will not normally generate enough voltage to be useful. But at those low speeds, if you short the generator output, the current induced in the coil generates another magnetic field to oppose the incoming magnetic field. Then remove the short and the magnetic field that was opposing disappears, causing a fast rate of change of flux and a corresponding high voltage. The transistor acts as the switch to connect and disconnect the short circuit and the rectifier automatically routes the boosted voltage to the rest of the circuit. (That is actually remarkably similar to how a magneto works.)
BTW, that description was based on Stephanie Wood's (a friend of mine) explanation of how it works. (She is actually really into Hobbit's articles.)
__________________
To my surprise, shortly after Naomi Wu gave me a bit of fame for making good use of solar power, Allie Moore got really jealous of her... |
12-07-09, 10:09 AM | #8 |
Lurking Renovator
Join Date: Dec 2009
Posts: 11
Thanks: 0
Thanked 0 Times in 0 Posts
|
not sure if someone mentioned this above, didnt have time to read it all, but by installing a cheap diode the motor will not turn the wheel and you will produce a lot more current. I made a pedal generator last year and use it all winter long. I can sustain about 80 watts avg for a good length of time so a lap top should be no problem with a diode in the positive line.
|
12-07-09, 10:26 AM | #9 | |
Infrequent noob
Join Date: Aug 2008
Location: 1000 Islands region, Ontario, Canada
Posts: 402
Thanks: 37
Thanked 20 Times in 19 Posts
|
Hi jimmo -
Got any pictures of your setup? Quite a few people have mentioned the diode in the YouTube comments. I didn't add one because it wasn't in my junk pile, and honestly I wouldn't know how to choose one for the job from Radio Shack (or wherever). Quote:
__________________
.
|
|
12-07-09, 02:50 PM | #10 |
Lurking Renovator
Join Date: Dec 2009
Posts: 11
Thanks: 0
Thanked 0 Times in 0 Posts
|
I cant say for shure but I think energy is being wasted on magnetising the coils in your motor even though you are spinning it faster than it will on its own. I could be wrong. I am going to try to bypass my diode and pedal mine the same way. If I can't sustain the same power as when I am using the diode then my theory is correct.
I got away with using radio shack diodes all of last winter but this year I upgraded to a 40 amp diode from ebay because I installed a watts up meter in line. If my radio shack diode failed it would ruin the meter and I was pushing the limits of those diodes. I had two installed in parallel. I will take some photos of it and post em later. In the winter I use it almost everyday. I power a television during my workout. Its pretty cool. I never realized how many people out there are doing things like this. lots of good info on this site... David Butcher: Pedal Powered Generator - DIY Plans |
Tags |
bike, generator, pedal |
|
|