![]() |
![]() |
#1 |
Helper EcoRenovator
Join Date: Jan 2012
Location: st.louis
Posts: 33
Thanks: 0
Thanked 1 Time in 1 Post
|
![]() I have access to a surplus of alcohol solutions. Either 70% Isopropanol or 70% Ethyl Alcohol.
Can someone think of a way to actually use this stuff? Is there a heater that it can be used in to heat a garage or something? Maybe mix it with something else then burn it? It flashes around 70 degrees F. |
![]() |
![]() |
![]() |
#2 |
Super Moderator
Join Date: May 2009
Location: Warsaw, Poland
Posts: 964
Thanks: 189
Thanked 111 Times in 87 Posts
|
![]() Sorry for the off-topic, but this is the first time I see someone complaining that they have too much alcohol and don't know what to do with it
![]() Seriously: Maybe mix it with gasoline to clean emissions?
__________________
Ecorenovation - the bottomless piggy bank that tries to tame the energy hog. |
![]() |
![]() |
![]() |
#3 | |
Supreme EcoRenovator
Join Date: Mar 2009
Location: Portland, OR
Posts: 4,004
Thanks: 303
Thanked 724 Times in 534 Posts
|
![]() Quote:
You could re-distill to a higher concentration of alcohol, and then use it for fuel. -AC
__________________
I'm not an HVAC technician. In fact, I'm barely even a hacker... |
|
![]() |
![]() |
![]() |
#4 |
Apprentice EcoRenovator
Join Date: Nov 2010
Location: Oklahoma City
Posts: 155
Thanks: 58
Thanked 17 Times in 14 Posts
|
![]() Donate them to your local health clinic or Salvation Army or ...you get the idea. Both are excellent disinfectants.
Chemistry labs sometimes use them for burners. You could do the same. |
![]() |
![]() |
![]() |
#5 |
Helper EcoRenovator
Join Date: Jan 2012
Location: st.louis
Posts: 33
Thanks: 0
Thanked 1 Time in 1 Post
|
![]() I actually have received 100% Isopropanol before. With that I would put a few gallons in my gas tank at every fill up. Worked fine.
I don't think this stuff would work as well. Don't really want to risk it. I have put some in my wiper fluid though. |
![]() |
![]() |
![]() |
#6 |
Helper EcoRenovator
Join Date: Nov 2014
Location: Michigan
Posts: 68
Thanks: 3
Thanked 2 Times in 2 Posts
|
![]() It would work as an antifreeze in a geothermal loop or experiments related?
|
![]() |
![]() |
![]() |
#7 |
Apprentice EcoRenovator
Join Date: Nov 2010
Location: Oklahoma City
Posts: 155
Thanks: 58
Thanked 17 Times in 14 Posts
|
![]() If you have enough to justify the cost of a $100 stainless steel still, you could always use it in your vehicle. At the current price if $4.75 for a gallon of gas here, that's what I'd do.
|
![]() |
![]() |
![]() |
#8 |
Supreme EcoRenovator
|
![]() Uhmm anything above about 50 percent will burn.
|
![]() |
![]() |
![]() |
#9 |
Apprentice EcoRenovator
Join Date: Nov 2010
Location: Oklahoma City
Posts: 155
Thanks: 58
Thanked 17 Times in 14 Posts
|
![]() I’d want the alcohol as close to 100% as I could put it in my vehicle because some moisture and water will fall out in the tank. I got the old Briggs and Stratton engines to run on 60% alcohol easy enough by adjusting the mixture screw.
|
![]() |
![]() |
![]() |
|
|