05-30-14, 08:07 AM | #31 |
Supreme EcoRenovator
Join Date: Oct 2008
Location: Austin, TX
Posts: 1,154
Thanks: 14
Thanked 257 Times in 241 Posts
|
You certainly don't need 130F water for that. 100F would be enough and the heat pump would do very well at that.
__________________
To my surprise, shortly after Naomi Wu gave me a bit of fame for making good use of solar power, Allie Moore got really jealous of her... |
The Following User Says Thank You to NiHaoMike For This Useful Post: | buffalobillpatrick (06-01-14) |
06-01-14, 06:55 PM | #32 |
Master EcoRenovator
Join Date: Mar 2014
Location: Florissant, Colorado
Posts: 599
Thanks: 814
Thanked 59 Times in 55 Posts
|
Here's an idea for my low cost Solar recharge of shallow loop field.
I'm trading some longbow building supplies that I no longer need, for 5x 3' x 8' great condition used solar hot water panels, that he don't need. Needed: 1,000' of 1" O2 barrier PEX. I already have: 260W of PV and 5x 24VDC El-Sid 10W pumps. The PV's are way more power than what's needed for the pumps (15' head) When Sun is providing enough Amps, the pumps circulate water through the hot water panels -> pex loop, charging the earth around ICF basement. This is a drain back system. If my DIY heat pump draws down the 1,000 gal. solar storage tank < 35*F I will have it switch over to drawing from the shallow loop. I would lay the pex in a slinky loop around the exterior, but 5' away, from the basement ICF walls. Cover the slinky loop with 12" sand before covering with about 3' of earth. Then put 4" EPS type2, that I already have, above & outside the slinky loop, then 2' of earth. Ideas, comments? Last edited by buffalobillpatrick; 06-01-14 at 07:07 PM.. |
06-01-14, 07:00 PM | #33 |
Supreme EcoRenovator
Join Date: Oct 2008
Location: Austin, TX
Posts: 1,154
Thanks: 14
Thanked 257 Times in 241 Posts
|
You'll do better with a differential controller selecting whichever source is higher in temperature.
__________________
To my surprise, shortly after Naomi Wu gave me a bit of fame for making good use of solar power, Allie Moore got really jealous of her... |
The Following User Says Thank You to NiHaoMike For This Useful Post: | buffalobillpatrick (06-01-14) |
06-01-14, 07:09 PM | #34 |
Master EcoRenovator
Join Date: Mar 2014
Location: Florissant, Colorado
Posts: 599
Thanks: 814
Thanked 59 Times in 55 Posts
|
NiHaoMike, Great Idea, I happen to have 3.
The way I have it planned, the heat pump can draw from loop field concurrent with it's solar charging or at night. Last edited by buffalobillpatrick; 06-01-14 at 07:11 PM.. |
06-01-14, 08:18 PM | #35 |
Master EcoRenovator
Join Date: Mar 2014
Location: Florissant, Colorado
Posts: 599
Thanks: 814
Thanked 59 Times in 55 Posts
|
Bury a water proof sensor out in dirt close to pex?
|
06-01-14, 09:50 PM | #36 |
Supreme EcoRenovator
Join Date: Oct 2008
Location: Austin, TX
Posts: 1,154
Thanks: 14
Thanked 257 Times in 241 Posts
|
That's one way to do it. You can actually attach it to the supply side of the loop, as lose to the heat pump as possible but far enough into the dirt that it can measure the true temperature even with the circulator pump off.
__________________
To my surprise, shortly after Naomi Wu gave me a bit of fame for making good use of solar power, Allie Moore got really jealous of her... |
The Following User Says Thank You to NiHaoMike For This Useful Post: | buffalobillpatrick (06-02-14) |
|
|