|
04-29-21, 03:24 PM
|
#1 |
|
Super Moderator
Join Date: Jun 2013
Location: SC
Posts: 2,923
Thanks: 172
Thanked 564 Times in 463 Posts
|
I am going to build a vacuum plate lifter.
I have lifting magnets but under ¼ plate they can be so so.
If I cut aluminum, the magnets will do nothing. Lifting 1/8 and under the magnets really do not work. Under 1/8” you can man handle. It will be based off a YouTube video I saw. I have almost everything on order to build it. I will have a remote control so you can run it from the forklift. Similar to what he did. I just looked at a couple commercial units and they had some good ideas I will use. I will put in switches at the pumps incase I want to lift a 1/2 sheet. They made the arms adjustable for smaller sheets. This may make since for us. I only lift 4'x 8' sheets Mine will have 6 8" suction cups. They can lift 180 pounds each.
__________________
Current project Aquaponics system , Passive Solar Greenhouse build To view links or images in signatures your post count must be 0 or greater. You currently have 0 posts. Solar Install 12.5 Kwh- To view links or images in signatures your post count must be 0 or greater. You currently have 0 posts. Mini Split installs - To view links or images in signatures your post count must be 0 or greater. You currently have 0 posts. EV Chevy Volt - To view links or images in signatures your post count must be 0 or greater. You currently have 0 posts. Last edited by pinballlooking; 04-29-21 at 04:42 PM.. |
|
|
|
|
Threaded Mode