![]() |
![]() |
#1 |
Land owner
Join Date: Nov 2012
Location: NM
Posts: 1,026
Thanks: 12
Thanked 127 Times in 107 Posts
|
![]() So day marks the beginning of my solar install.
Step 1, up grade by adding a new 125 amp square d QO outdoor panel and remove as much inappropriate wiring as possible. The thorn in my foot is the 6/2 with ground UF-B wire running out to my solar panel area back to the main panel. It's on a tandem breaker which means the neutral and ground were running on the bare wire. Not good, never would have come any where close to passing inspection like that. I think what I will end up doing is reusing this wire to run a 240 welder circuit out to my solar panel and animal pen area then run conduit and run new proper wire out there. I have pics but I will need to resize them or take new ones with my digital camera. |
![]() |
![]() |
Tags |
diy, garage, heat pump, inverter, solar |
|
|