![]() |
![]() |
#1 |
Super Moderator
Join Date: Jun 2013
Location: SC
Posts: 2,923
Thanks: 172
Thanked 564 Times in 463 Posts
|
![]() I bought a PWC Floatair lift over the weekend. It is $1,400 for a new lift like this one.
This one was being sold for $200. But some of the steel that stays below the water line needed replaced. I found a surplus metal place down town Greenville. I was able to buy stainless steel 2” square tubing and 1”1/2 inch flat bar and some 3” flat bar all for $1 a pound. All parts cost $75 I ordered some stainless steel mig welding wire for $25. I will be putting my welder back to work. The metal that rusted out was not stainless steel so this all should last much longer. It is similar to this one. A side note these operate with a pretty cool design. They use a whole house vacuum blower motor (in the white box in the picture) to blow air into the tank this displaces the water out a hole that is in the bottom of the tank. The air lifts the Jet Ski out of the water. Then when it is time to ride you just turn a valve this lets out the air and let’s water in this sinks the dock. Very simple.
__________________
Current project Aquaponics system , Passive Solar Greenhouse build To view links or images in signatures your post count must be 0 or greater. You currently have 0 posts. Solar Install 12.5 Kwh- To view links or images in signatures your post count must be 0 or greater. You currently have 0 posts. Mini Split installs - To view links or images in signatures your post count must be 0 or greater. You currently have 0 posts. EV Chevy Volt - To view links or images in signatures your post count must be 0 or greater. You currently have 0 posts. Last edited by pinballlooking; 07-19-16 at 01:39 PM.. |
![]() |
![]() |
|
|