04-25-14, 01:03 PM | #11 |
Super Moderator
Join Date: Jun 2013
Location: SC
Posts: 2,923
Thanks: 172
Thanked 564 Times in 463 Posts
|
We have been making a brushless remote control car.
We have all the pieces printed out and we have the parts ordered all over the world. The car is printed out PLA and the Gray is all ABS that is stronger for the gears… We did not have the printer on the right setting on the red interior. But it was not worth reprinting it because it is just the interior. It has been a fun project so far. Last edited by pinballlooking; 04-25-14 at 02:38 PM.. |
|
|