![]() |
![]() |
#1 |
Super Moderator
Join Date: Jun 2013
Location: SC
Posts: 2,923
Thanks: 172
Thanked 564 Times in 463 Posts
|
![]() My M2 MakerGear 3D printer kit should be here Saturday. This is my first 3D printer so we are looking forward to getting it.
It's print area is 8" x 10" x 8" Build Area "Typical layer heights are between 0.3mm and 0.1mm but sometimes go below 0.05mm" M Series 3D Printers | MakerGear I think I will setup a small work bench in the garage to put the printer on. I read the fumes printing ABS can be bad and it can take a very long time to print. The noise can stay out there. Last edited by pinballlooking; 05-19-14 at 05:06 PM.. |
![]() |
![]() |
|
|