|
|
|
08-04-14, 06:49 PM
|
#1 |
|
Helper EcoRenovator
Join Date: Mar 2011
Location: Roswell NM
Posts: 43
Thanks: 0
Thanked 4 Times in 4 Posts
|
No load turbine speed
I can't find a definitive answer on the internet so I hope the forum can help.
What would be the approximate shaft RPM of a 2 meter horizontal 3 blade mill in an 8MPH wind with no load, just free rotation? An odd question, but I am putting an idea together to see if it is viable  |
|
|
|
08-04-14, 10:13 PM
|
#2 |
|
Steve Hull
Join Date: Dec 2012
Location: hilly, tree covered Arcadia, OK USA
Posts: 826
Thanks: 241
Thanked 165 Times in 123 Posts
|
Could be as high as several hundred rpm - depending on bearing friction.
Steve
__________________
consulting on geothermal heating/cooling & rational energy use since 1990 |
|
|
|
|
08-05-14, 09:11 AM
|
#3 |
|
Master EcoRenovator
Join Date: Mar 2009
Location: Western Wisconsin.
Posts: 913
Thanks: 127
Thanked 82 Times in 71 Posts
|
Blade design and pitch is going to dictate the free spinning speed to a point.
It also depends on what style of over-speed protection it has. |
|
|
|
|
08-20-14, 06:27 PM
|
#4 |
|
Helper EcoRenovator
Join Date: Mar 2011
Location: Roswell NM
Posts: 43
Thanks: 0
Thanked 4 Times in 4 Posts
|
I can bore you with my plan, which may help answer the question. I could do with some input before I expend too much energy or worse, money
 |
|
|
|
 |
|
|
Hybrid Mode
