View Single Post
Old 06-17-21, 07:19 PM   #5
pinballlooking
Super Moderator
 
pinballlooking's Avatar
 
Join Date: Jun 2013
Location: SC
Posts: 2,923
Thanks: 172
Thanked 564 Times in 463 Posts
Default

I asked some people that know more about punching thick steel than I do. They said that it would not work for a bucket pin where the pin was moving.
So I scrapped that idea.
My new presses have a single acting hydraulic pumps.
I just ordered CH-70 and it will use one of those pumps. I will need to add a quick connector for the hydraulic line.

I have a 5 off coupon. Not to bad for a shipped price.
I will need to get some square dies and oblong ones.

some specs.


Here is one working.
It is like this one and this video is in English.





I would have bought the 50 ton one but it requires double acting hydraulic pump and I only have single acting pumps.
Attached Images
  
__________________
Current project Aquaponics system , Passive Solar Greenhouse build

To view links or images in signatures your post count must be 0 or greater. You currently have 0 posts.

Solar Install 12.5 Kwh-
To view links or images in signatures your post count must be 0 or greater. You currently have 0 posts.

Mini Split installs -
To view links or images in signatures your post count must be 0 or greater. You currently have 0 posts.

EV Chevy Volt -
To view links or images in signatures your post count must be 0 or greater. You currently have 0 posts.

Last edited by pinballlooking; 06-17-21 at 08:11 PM..
pinballlooking is offline   Reply With Quote