I am not sure I am going to make a track now. I really like the clean straight cuts you can make with it.
I am going to make the modified builders square one. I just bought a builder’s square to make it.
I have been using my new cutter and as long as I have a guide, I am doing a pretty good job cutting straight. I got a stand off that really helps.
I was using my plasma cutter tonight and my welder ground was connected but I thought it was my plasma cutter ground. (They look the same)
I was trying to cut ½ plate. It was not working very well at all. I messed my tip up.
Then I saw my ground was not connected.
It cut so much better with the ground connected.