View Single Post
Old 03-16-21, 02:45 PM   #91
Daox
Administrator
 
Daox's Avatar
 
Join Date: Aug 2008
Location: Germantown, WI
Posts: 5,525
Thanks: 1,162
Thanked 374 Times in 305 Posts
Default

I found a quick use for my 3d printer over last weekend. I was redoing some trim in my hallway and I have a big rounded corner. The previous trim just came out straight leaving a big triangular gap which was ugly and always filled up with junk. I was a bit stumped for a bit thinking about how I was going to do it before I remembered that I have a 3d printer. So, I measured up the trim and modeled up the 90 degree piece and voala...


Attached Images
 
__________________
Current project -
To view links or images in signatures your post count must be 0 or greater. You currently have 0 posts.



To view links or images in signatures your post count must be 0 or greater. You currently have 0 posts.
&
To view links or images in signatures your post count must be 0 or greater. You currently have 0 posts.
Daox is offline   Reply With Quote