View Single Post
Old 02-23-21, 05:56 PM   #17
pinballlooking
Super Moderator
 
pinballlooking's Avatar
 
Join Date: Jun 2013
Location: SC
Posts: 2,923
Thanks: 172
Thanked 564 Times in 463 Posts
Default

I did the home Hydro test. Filled it completely with water. Then used pressure washer to pressurize it.
I pressure tested it to 310 psi. it held good. With this test I would feel good at even 175 psi but it probably move it down to 155 psi.

Knowing the pressure washer limitation not going any higher than 250 psi once you let off the trigger. I made it so I could watch the gauge as I pressurized it. When I saw it 300 I let off.

No leaks good to go.

Attached Images
 
__________________
Current project Aquaponics system , Passive Solar Greenhouse build

To view links or images in signatures your post count must be 0 or greater. You currently have 0 posts.

Solar Install 12.5 Kwh-
To view links or images in signatures your post count must be 0 or greater. You currently have 0 posts.

Mini Split installs -
To view links or images in signatures your post count must be 0 or greater. You currently have 0 posts.

EV Chevy Volt -
To view links or images in signatures your post count must be 0 or greater. You currently have 0 posts.

Last edited by pinballlooking; 02-23-21 at 08:06 PM..
pinballlooking is offline   Reply With Quote