View Single Post
Old 03-07-21, 10:30 PM   #90
pinballlooking
Super Moderator
 
pinballlooking's Avatar
 
Join Date: Jun 2013
Location: SC
Posts: 2,923
Thanks: 172
Thanked 564 Times in 463 Posts
Default

I have a pressurized Geo system it has recently loosing pressure.
The fittings that came with the kit were shark bite style fittings for the 1” Pex. There was six of these fittings. They all were dripping. They were covered in pipe insulation so it was hard to see.

They get condensation so it is not apparent that it was happing. One fitting had drip when there was no condensation.

I got the razor blade and found one leak. Then a cut open all fitting like this one and everyone had a drip.

I replaced all of them with crimp fittings. I just checked again after A few hours and it still had good pressure.
I will check tomorrow and some going forward to make sure I have good pressure.



These worked for two years not sure why they just are not working anymore but they are all gone now.
Attached Images
 
__________________
Current project Aquaponics system , Passive Solar Greenhouse build

To view links or images in signatures your post count must be 0 or greater. You currently have 0 posts.

Solar Install 12.5 Kwh-
To view links or images in signatures your post count must be 0 or greater. You currently have 0 posts.

Mini Split installs -
To view links or images in signatures your post count must be 0 or greater. You currently have 0 posts.

EV Chevy Volt -
To view links or images in signatures your post count must be 0 or greater. You currently have 0 posts.

Last edited by pinballlooking; 03-08-21 at 07:19 AM..
pinballlooking is offline   Reply With Quote