EcoRenovator - View Single Post - I ordered a 4x4 CNC plasma table

The most it will be lifting is ½” plate about 653 pounds.
My tractor just lifted 3/8” plate about 500 pounds.

I checked my hydraulic pressure and mine was low on my tractor I bumped it up and it was able the lift the 3/8 plate.

__________________
Current project Aquaponics system , Passive Solar Greenhouse build

To view links or images in signatures your post count must be 0 or greater. You currently have 0 posts.

Solar Install 12.5 Kwh-
To view links or images in signatures your post count must be 0 or greater. You currently have 0 posts.

Mini Split installs -
To view links or images in signatures your post count must be 0 or greater. You currently have 0 posts.

EV Chevy Volt -
To view links or images in signatures your post count must be 0 or greater. You currently have 0 posts.

01-07-20, 01:27 PM	#31
pinballlooking Super Moderator Join Date: Jun 2013 Location: SC Posts: 2,923 Thanks: 172 Thanked 564 Times in 463 Posts	The most it will be lifting is ½” plate about 653 pounds. My tractor just lifted 3/8” plate about 500 pounds. I checked my hydraulic pressure and mine was low on my tractor I bumped it up and it was able the lift the 3/8 plate. __________________ Current project Aquaponics system , Passive Solar Greenhouse build To view links or images in signatures your post count must be 0 or greater. You currently have 0 posts. Solar Install 12.5 Kwh- To view links or images in signatures your post count must be 0 or greater. You currently have 0 posts. Mini Split installs - To view links or images in signatures your post count must be 0 or greater. You currently have 0 posts. EV Chevy Volt - To view links or images in signatures your post count must be 0 or greater. You currently have 0 posts. Last edited by pinballlooking; 01-07-20 at 08:57 PM..