View Single Post
Old 03-27-17, 01:49 PM   #5
pinballlooking
Super Moderator
 
pinballlooking's Avatar
 
Join Date: Jun 2013
Location: SC
Posts: 2,923
Thanks: 172
Thanked 564 Times in 463 Posts
Default

"I just have a miller spectrum 625 I bought back in 2004."
That is a much nicer plasma cutter than what I bought.

This one takes cut 50 consumables.
311716842267 | eBay

I did check I could that I could get consumables before deciding on this one. Getting parts does concern me I hope I have as good luck as my brother has had.

I have looked on Clist for a long time for a cheap used USA made one with no luck. I do believe it is a gamble getting this one. I did not take that gamble on my welder because I knew I would use it a fair amount. I bought the Hobart 140 handler I have been happy with it.

But for $200 I will give this one a chance.

I have a small pancake compressor 120 150 psi. But I also have a bigger 240 compressor that can handle a good load.
__________________
Current project Aquaponics system , Passive Solar Greenhouse build

To view links or images in signatures your post count must be 0 or greater. You currently have 0 posts.

Solar Install 12.5 Kwh-
To view links or images in signatures your post count must be 0 or greater. You currently have 0 posts.

Mini Split installs -
To view links or images in signatures your post count must be 0 or greater. You currently have 0 posts.

EV Chevy Volt -
To view links or images in signatures your post count must be 0 or greater. You currently have 0 posts.

Last edited by pinballlooking; 03-28-17 at 03:59 AM..
pinballlooking is offline   Reply With Quote