View Single Post
Old 03-23-20, 03:23 PM   #5
pinballlooking
Super Moderator
 
pinballlooking's Avatar
 
Join Date: Jun 2013
Location: SC
Posts: 2,913
Thanks: 170
Thanked 558 Times in 458 Posts
Default

Thanks.
I had one step that I did not get good powder coat coverage. I was able to sand blast it off pretty easily.
You only have to use about two or three cups of media

My shop vac is back and running the winding that was broken was never soldered at the factory. It is strange the other side was soldered.
It needed a good cleaning.
__________________
Current project Aquaponics system , Passive Solar Greenhouse build

To view links or images in signatures your post count must be 0 or greater. You currently have 0 posts.

Solar Install 12.5 Kwh-
To view links or images in signatures your post count must be 0 or greater. You currently have 0 posts.

Mini Split installs -
To view links or images in signatures your post count must be 0 or greater. You currently have 0 posts.

EV Chevy Volt -
To view links or images in signatures your post count must be 0 or greater. You currently have 0 posts.

Last edited by pinballlooking; 03-23-20 at 09:26 PM..
pinballlooking is offline   Reply With Quote