Quote:
Originally Posted by Xringer
I went back and read it again.. They don't want any power going into the HW heater...
Warnings
When installing the AirTap™on a gas or electric water heater, disconnect permanently the gas or power supply to the water heater while the AirTap™is being installed. The original gas/power supply to the gas/electric water heater shall remain disconnected after installation.
Seems odd to me. The Hybrid units being sold these days are using both modes of water heating..
|
Probable the reason they want you to disconnect other heat source because what if your thermostat fails? HWT can reach over 100 C (boiling water + pressure). You have their refrigeration lines (full of liquid refrigerant) inside this super hot water. Think what is going to happen next???