View Single Post
Old 02-01-21, 08:01 AM   #9
pinballlooking
Super Moderator
 
pinballlooking's Avatar
 
Join Date: Jun 2013
Location: SC
Posts: 2,815
Thanks: 165
Thanked 535 Times in 439 Posts
Default

I let it sit over night and it is leaking air through the check valve. I found a new one on eBay $11.73 shipped it is on the way.



I ordered a new pressure switch I did not need an expensive one because I did not need a built-in unloader. I bought a square D for $17.12 shipped.

This HF tool worked great for taking off the pulley and removing the bearings.
https://www.harborfreight.com/bearin...set-62593.html
I had it sitting on the shelf for a long time. Glad I got to use it.



I have the motor apart. Time to look at the bearings they are squeaking when running.
I have two new NTN Radial Ball Bearing, Double Shielded on the way for the motor.
$13.06 Shipped.

When I hydro test it I will test the safety valve if it is not working correctly I will replace it then.
Attached Images
  
__________________
Current project Aquaponics system , Passive Solar Greenhouse build

To view links or images in signatures your post count must be 0 or greater. You currently have 0 posts.

Solar Install 12.5 Kwh-
To view links or images in signatures your post count must be 0 or greater. You currently have 0 posts.

Mini Split installs -
To view links or images in signatures your post count must be 0 or greater. You currently have 0 posts.

EV Chevy Volt -
To view links or images in signatures your post count must be 0 or greater. You currently have 0 posts.

Last edited by pinballlooking; 02-01-21 at 10:00 PM..
pinballlooking is offline   Reply With Quote