EcoRenovator - View Single Post

Xringer · 09-08-16, 01:46 PM

My wife thinks the old Sanyo IDU's look better..

Flare inspection was disappointing. I haven't made a lot of flares,
but I think that I could have done a better job on the 1/4" connections..
The 5/8 flares didn't impress me much either.
I've seen better.. But I've only purchased two linesets before..

The 1/4" started hissing at 50 psi.. So, I turned it down some more.. Actually twice, before it stopped.

It's been just above 200 PSI for the last 2 hours. I've not put the ladder back up,
to perform the bubble test.. Yet.. I might just let this 200 PSI sit overnight..
Go back to work in the AM.. This afternoon, I can do the wiring..

The lineset is so long, it's taking up a lot of room behind the ODU..
Not liking this long line set..

09-08-16, 01:46 PM	#21
Xringer Lex Parsimoniae Join Date: Feb 2009 Location: Woburn, MA Posts: 4,918 Thanks: 114 Thanked 250 Times in 230 Posts	This 25' line set seems like it's 35 feet.. Too long.. My wife thinks the old Sanyo IDU's look better.. Flare inspection was disappointing. I haven't made a lot of flares, but I think that I could have done a better job on the 1/4" connections.. The 5/8 flares didn't impress me much either. I've seen better.. But I've only purchased two linesets before.. The 1/4" started hissing at 50 psi.. So, I turned it down some more.. Actually twice, before it stopped. It's been just above 200 PSI for the last 2 hours. I've not put the ladder back up, to perform the bubble test.. Yet.. I might just let this 200 PSI sit overnight.. Go back to work in the AM.. This afternoon, I can do the wiring.. The lineset is so long, it's taking up a lot of room behind the ODU.. Not liking this long line set.. Attached Images __________________ My hobby is installing & trying to repair mini-splits EPA 608 Type 1 Technician Certification ~ 5 lbs or less..