View Single Post
Old 07-19-21, 09:50 AM   #1
pinballlooking
Super Moderator
 
pinballlooking's Avatar
 
Join Date: Jun 2013
Location: SC
Posts: 2,923
Thanks: 172
Thanked 564 Times in 463 Posts
Default I bought an Ex-cell-o Mill (XLO) first gen mill Saturday 7/17/21.

I picked the Ex-cell-o Mill (XLO). 3 phase grinder 12” wheels and a Quincy QR 25 240 – 12 pump/motor that will need some work but turns over and it is putting out air.
The Quincy sat outside for some time but I think I can make it look nice and work good down the road.

The mill was $1200 he sold me the grinder and Quincey pump for $60
I saw it as soon as it was posted to marketplace and jumped on it.
He gave me 4 16' prices of angle iron. they are rusty but I can make oven racks out of it.

It took my new grinders VFD to test it out and convert it from 3 phase to one phase. but I did not take extra wiring. I use there wiring and it go a over current error. It did run for a min it was quite.

The guy that owner it passed away they did not know anything about it.

It was made in Canada. Their claim to fame was they were better than Bridgeport Quill bigger 1" longer heaver...

I have a lot to learn I have never used a mill.
It weights like 2800 pounds.
It takes R8 tooling

















Attached Images
        
__________________
Current project Aquaponics system , Passive Solar Greenhouse build

To view links or images in signatures your post count must be 0 or greater. You currently have 0 posts.

Solar Install 12.5 Kwh-
To view links or images in signatures your post count must be 0 or greater. You currently have 0 posts.

Mini Split installs -
To view links or images in signatures your post count must be 0 or greater. You currently have 0 posts.

EV Chevy Volt -
To view links or images in signatures your post count must be 0 or greater. You currently have 0 posts.
pinballlooking is offline   Reply With Quote