View Single Post
Old 02-12-21, 08:55 AM   #5
pinballlooking
Super Moderator
 
pinballlooking's Avatar
 
Join Date: Jun 2013
Location: SC
Posts: 2,923
Thanks: 172
Thanked 564 Times in 463 Posts
Default

I ordered a VFD to run the 3 phase motor. You can use the pressure switch to tell the VFD to start and stop.



The pressure switch only breaks a ground so I can use the cheap pressure switch I already bought. I will use the pressure gauge I already bought for this compressor.



I also ordered two new diaphragms for the unloaders. They wear out over time so they will need to be replaced.

I ordered a new gauge for the oil pump.




That is all I getting until I test it out.
Attached Images
    
__________________
Current project Aquaponics system , Passive Solar Greenhouse build

To view links or images in signatures your post count must be 0 or greater. You currently have 0 posts.

Solar Install 12.5 Kwh-
To view links or images in signatures your post count must be 0 or greater. You currently have 0 posts.

Mini Split installs -
To view links or images in signatures your post count must be 0 or greater. You currently have 0 posts.

EV Chevy Volt -
To view links or images in signatures your post count must be 0 or greater. You currently have 0 posts.

Last edited by pinballlooking; 02-13-21 at 06:35 PM..
pinballlooking is offline   Reply With Quote