Ground Source Shop Warmer now working...
I have re-configured my heat pump to work as a Ground Source Shop Warmer. It is now running, warming my uninsulated basement shop.
I borrowed an automobile radiator from Bruce-the-Pirate and hooked up the output water loop (and circulation pump) to it. The setup, crude as it is, is working.
I'm using a box fan to blow air through the radiator.
The ground loop temperature pulled down to about 46 degrees... the radiator-loop temperature stabilized at around 73 degrees and after running it for several hours, the temperature in the unheated basement stabilized at 60 F... not too bad for a shop.
I haven't calculated efficiency for the setup (my estimate is COP =2), but it is clearly better than the 220 V, 2400 watt resistance heater I was previously using.
-AC_Hacker
Last edited by AC_Hacker; 01-05-11 at 11:37 AM..
|