View Single Post
Old 12-17-19, 05:46 PM   #17
pinballlooking
Super Moderator
 
pinballlooking's Avatar
 
Join Date: Jun 2013
Location: SC
Posts: 2,923
Thanks: 172
Thanked 564 Times in 463 Posts
Default

I finally have a spot cleaned out to put my plasma table. I still need to wire my new compressor and run its air lines. I wanted to be able to load the table with my tractor. This location should allow me to do this.




Here is 1/2" 3/8" and 1/4" mild steel cut.
Attached Images
  
__________________
Current project Aquaponics system , Passive Solar Greenhouse build

To view links or images in signatures your post count must be 0 or greater. You currently have 0 posts.

Solar Install 12.5 Kwh-
To view links or images in signatures your post count must be 0 or greater. You currently have 0 posts.

Mini Split installs -
To view links or images in signatures your post count must be 0 or greater. You currently have 0 posts.

EV Chevy Volt -
To view links or images in signatures your post count must be 0 or greater. You currently have 0 posts.

Last edited by pinballlooking; 12-17-19 at 08:46 PM..
pinballlooking is offline   Reply With Quote