View Single Post
Old 05-17-11, 10:39 PM   #4
dh1
Helper EcoRenovator
 
Join Date: May 2011
Location: Ont. Canada
Posts: 99
Thanks: 14
Thanked 11 Times in 9 Posts
Default First Test Drive

Time to see if it works, no controller has been bought yet, I have a control panel from a 36 volt floor sweeper that I bought at the same time as the motor and it has 36volt solenoids on it. I mounted 1 and put a cable with a battery booster clamp on it so I could select 12, 24, or 36volts for testing. I used a small jumper wire to turn the solenoid on and off.
It worked, 12volts had enough to move it self but that's about it.
24volts much more power.
36volts even more power.
1 problem that showed up was some clucking and mushiness from the rear end, thought it was the belt slipping at the time.
Attached Images
     
dh1 is offline   Reply With Quote