Quote:
Originally Posted by jeff5may
Sounds like it's time to make a decision. I have very little confidence in the stop leak product. It may get you through the summer though.
I chopped up a brand new can tapper this year to use with my gauge set. The truck needed a flush and fill after a compressor burnout and the Saturn blew the thermal fuse embedded inside the magnetic clutch. All of the can taps that had flare (acme) fittings on them were car size and wouldn't fit my home size gauge set. So I bought one of these:
I put access valve tubes just like the one in your unit on the ends of the hoses.
Now both halves connect right up to my gauge set.
|
Jeff,
How did you get the copper tubes sealed into the tube?
The copper OD is a pretty good match for the ID of the hose..
But, the inside of the hose is smooth and the copper is smooth..
There is oil inside the tube,
w/ the clamp tight the copper slides right out!
I think the R410a is going blow that copper right across the room!
PS: I'm going to use the empty can to test for hose leakage..
Thanks,
Rich