View Single Post
Old 06-13-19, 05:24 PM   #15
Xringer
Lex Parsimoniae
 
Xringer's Avatar
 
Join Date: Feb 2009
Location: Woburn, MA
Posts: 4,860
Thanks: 105
Thanked 244 Times in 224 Posts
Default

Quote:
Originally Posted by brian View Post
If it's not too late (scrapped tank), we used what they called (wickin) to help seal sloppy threads. This was candle wicking (cotton thread) which was wrapped around the male threads and covered with pipe dope. Never had a leaking thread that coud not be repaired with this. In an emergency we use a wet mop thread which has been unwound to get a smaller thread and it usually works great, cotton preferred.
I learned about using cotton string around sink drain couplings a few years ago.
The Ace Hardware guy told me the old plumbers trick of over-wrapping the threads in string,
and the water would make it swell up, to stop the leakage..
It works great on low pressure drains.. But for 50 to 100 PSI? I don't know.

In any event, I'm gonna be heating with the old oil burner for a while..
It's uses oil, but not a lot. Plus, it's a HS Tarm multi-fuel and can
run on wood, coal, propane & etc. If the grid fails us again, we're good..
__________________
My hobby is installing & trying to repair mini-splits
EPA 608 Type 1 Technician Certification ~ 5 lbs or less..
Xringer is offline   Reply With Quote