View Single Post
Old 08-12-20, 08:25 PM   #17
nokiasixteth
Journeyman EcoRenovator
 
Join Date: Jan 2014
Location: Earth
Posts: 348
Thanks: 43
Thanked 14 Times in 13 Posts
Default

The other wire of the fuse holder will attach to the board above the triangle with the exclamation point. I would attach it to the siver terminal above where the burnt trace is. Again, make a solder blob, then attach the wire to the blob.


The spots in the red is where i tried to solder . It didnt seem to want to stick . I had to put a substantial blob. The black circle kinda in the middle of that solder stuff is that a better spot to solder ? . This circuit board i have no clue what goes where.
Attached Images
 
nokiasixteth is offline   Reply With Quote