View Single Post
Old 07-23-20, 02:22 AM   #14
jeff5may
Supreme EcoRenovator
 
Join Date: Jan 2010
Location: elizabethtown, ky, USA
Posts: 2,372
Thanks: 390
Thanked 601 Times in 503 Posts
Send a message via Yahoo to jeff5may
Default

For what it's worth, I have a gaggle of teensy soldering stuff for electronics. My go to is the Weller. All the super pro somewhat expert peanuts have their gadgets of the day, but guess what? Weller wtcp series works for me and lots of pros that actually fix a lotta stuff. Old blue still kicking, manufactured 1973. I have a couple of tc202 stations as well. All the irons work with all the stations. Tc201. All the tips work with all the irons. Twisty knob and LCD control gimmicky stuff not for me. The tips have a number on the shank that tells the heat. Number 7, 700 degrees. Number 5, 500 degrees. Weller makes every kind of soldering iron tip you could imagine for the tc201.

Hot air stations: you get what you pay for. If you're not fixing phones or MacBooks and don't have a microscope, forget it.

For your board, a 12 dollar iron, some tip tinner (sal ammoniac), solder with lead, a small roll of chem-wick rosin, and some 91 percent alcohol for cleaning should do you. Maybe an xacto knife for scraping and cutting.

To be honest, an xacto knife is my favorite surface mount component removal tool. If it has 4 or less terminals, a little poking and prodding makes itty bitty sand based lifeforms disappear. Micro tiny surface mounted sand is the main reason I got out of consumer electronic repair.

Last edited by jeff5may; 07-23-20 at 02:44 AM.. Reason: Updated dead links
jeff5may is offline   Reply With Quote
The Following User Says Thank You to jeff5may For This Useful Post:
nokiasixteth (07-29-20)