View Single Post
Old 03-02-20, 10:02 AM   #4
menaus2
Apprentice EcoRenovator
 
menaus2's Avatar
 
Join Date: Feb 2011
Location: Driftless Region, North America, Earth, Solar System, Orion Arm, Milky Way Galaxy,Virgo Supercluster
Posts: 116
Thanks: 13
Thanked 33 Times in 25 Posts
Default

Heat exchanger coils are wound in the tank. It wasn't easy hanging over into the tank for a few hours, but it got easier as I worked my way higher in the tank. I had a 24" diameter by 30"H space to work with. The 1/2" OD refrigeration line was easy to bend, and I only had a couple spots where there was a minor dimple from bending it too tight. I used 14ga copper electric wire to space the coils & keep everything tidy.

From what I've researched with wort chillers used for brewing, it's a good idea for coils to be separated into different "zones". The first coil is laid out as a disk at the bottom of the tank. The second is a cylinder at the bottom half, then the third coil in a similar way above that. The fourth is a tighter coil in the middle from bottom to top. Currently I'm building the manifolds out of PEX and will attach it to the lines with flare fittings. With the tight space it should be a challenge!











Attached Images
      
__________________
Resiliency is the new sustainability.

The Things to do are: the things that need doing, that you see need to be done, and that no one else seems to see need to be done. -Buckminster Fuller

Last edited by Daox; 03-11-20 at 01:40 PM..
menaus2 is offline   Reply With Quote
The Following 2 Users Say Thank You to menaus2 For This Useful Post:
Daox (03-11-20), skyking (03-14-20)