View Single Post
Old 02-23-14, 09:23 PM   #4
pinballlooking
Super Moderator
 
pinballlooking's Avatar
 
Join Date: Jun 2013
Location: SC
Posts: 2,767
Thanks: 162
Thanked 531 Times in 435 Posts
Default

I finished the putting together the open source EVSE. It is now helping my Chevy Volt get charged up.
One good side benefit is it uses less than 1 watt in standby. This should help in my quest to lower my standby load.

It was a lot of drilling and getting everything to fit in the box. The 10 gauge wire is very stiff to work with. I am happy with the end results.
For the 8 gauge wire I used left over pieces from my solar project.

The second picture shows it actually charging my Volt.

I based my component layout off this build.
http://code.google.com/p/open-evse/wiki/30A_OpenEVSE


A lot of the parts I ordered were based off this build.
http://code.google.com/p/open-evse/wiki/EVSE_by_4Dolio



Attached Images
  

Last edited by pinballlooking; 02-05-17 at 11:43 PM..
pinballlooking is offline   Reply With Quote