Here's an overly compressed picture of some progress I made on the panel.
Here I'm basically dry fitting all the parts ignore the baffle placement in the manifolds. I plan to spray more paint on some of the tubes. I need to do some testing after I install the manifold front covers and hold the glass down to the front. I will be deciding where to put the inlet and outlet as well as how many tubes to run in a parallel circuit by moving the baffles around in the manifolds. I ended up buying a 12ft piece of aluminum material that is flat to use for the manifold front covers. It should be alote easier to install than coiled flashing.
Last edited by jwxr7; 07-30-09 at 03:14 PM..
|