Hi Opiesche,
I ran across your post on the raspberry pi and it caught my attention. I'm working on building a house with a radiant floor in the slab. And I'm also using a pi to control/monitor everything that I can. I'm also using the same sensors you are, as they are super easy to setup and use, with the built-in I2C networking capabilities of the pi.
I have mine setup to record test temp measurements in my workroom for now. But I'm going to try to log temps from the following different locations in our slab/house:
1. multiple zone circuits within the slab
2. Underneath the slab, in the earth
3. inside the house, air temp
4. outside the house, air temp
I don't have much going yet on the web page side of this, but I'm still looking for different ideas/solutions out there for this.
|