EcoRenovator - View Single Post - I just bought two 55-ton Power Team SPX hydraulic presses off marketplace.

pinballlooking · 06-24-21, 04:26 PM

If you could fine some good H beams you could build one.

Thanks. We have been really enjoying the new presses. I will take a short video of it bending ¼ steel. It does not even break a sweet.

I sold my 40 ton press and applied that money toward these. that brought these down to $825.
https://ecorenovator.org/forum/showthread.php?t=7341

I just ordered quick connects for one of the pumps so I can connect up the new hydraulic punch. That thing is heavy.

Still debating on ordering a 100 ton punch from china. I will see how the holes look with this one before I decide to spend that much money. It may be possible to punch hole a little under size and ream it.

I am going to try a Drill-Use Annular Cutter adapter. It just came in.
My cheap drill press goes down to 300 rpm so it may be good for this job.
Yes this is going into my $10 drill press.
https://ecorenovator.org/forum/showthread.php?t=7196

06-24-21, 04:26 PM	#7
pinballlooking Super Moderator Join Date: Jun 2013 Location: SC Posts: 2,923 Thanks: 172 Thanked 564 Times in 463 Posts	If you could fine some good H beams you could build one. Thanks. We have been really enjoying the new presses. I will take a short video of it bending ¼ steel. It does not even break a sweet. I sold my 40 ton press and applied that money toward these. that brought these down to $825. https://ecorenovator.org/forum/showthread.php?t=7341 I just ordered quick connects for one of the pumps so I can connect up the new hydraulic punch. That thing is heavy. Still debating on ordering a 100 ton punch from china. I will see how the holes look with this one before I decide to spend that much money. It may be possible to punch hole a little under size and ream it. I am going to try a Drill-Use Annular Cutter adapter. It just came in. My cheap drill press goes down to 300 rpm so it may be good for this job. Yes this is going into my $10 drill press. https://ecorenovator.org/forum/showthread.php?t=7196 Attached Images __________________ Current project Aquaponics system , Passive Solar Greenhouse build To view links or images in signatures your post count must be 0 or greater. You currently have 0 posts. Solar Install 12.5 Kwh- To view links or images in signatures your post count must be 0 or greater. You currently have 0 posts. Mini Split installs - To view links or images in signatures your post count must be 0 or greater. You currently have 0 posts. EV Chevy Volt - To view links or images in signatures your post count must be 0 or greater. You currently have 0 posts.