EcoRenovator - View Single Post

greif · 12-31-12, 05:01 PM

I have a 2001 JD gator 4 x 2 (2 wheel drive). It had an under powered air cooled single cylinder 10hp motor. Plowing snow with it was a little hard on that motor and it would get hot and start to rattle. So I found a good shunt wound motor D & D brand ES-32C-7 elec motor and stripped it down and went about putting it in. Since it is shunt would it has regen. I set it up for 72 volts and have 6 12v batteries and an additonal 12v batt for acesories.

I origanaly had it extra heavy duty cogged belt drive but it has so much torqure I had to switch to chain drive since the belt would jump.
motor specs
48-72VDC
9 HP @ 72V Continuous Rated
60 Ft /Lbs Torque Peak
31 HP Peak with a 500 Amp Controller

12-31-12, 05:01 PM	#1
greif a van down by the river Join Date: Jun 2011 Location: Kaukauna,WI Posts: 108 Thanks: 6 Thanked 5 Times in 5 Posts	convert John Deere Gator to electric I have a 2001 JD gator 4 x 2 (2 wheel drive). It had an under powered air cooled single cylinder 10hp motor. Plowing snow with it was a little hard on that motor and it would get hot and start to rattle. So I found a good shunt wound motor D & D brand ES-32C-7 elec motor and stripped it down and went about putting it in. Since it is shunt would it has regen. I set it up for 72 volts and have 6 12v batteries and an additonal 12v batt for acesories. I origanaly had it extra heavy duty cogged belt drive but it has so much torqure I had to switch to chain drive since the belt would jump. motor specs 48-72VDC 9 HP @ 72V Continuous Rated 60 Ft /Lbs Torque Peak 31 HP Peak with a 500 Amp Controller Attached Images __________________ Gary R “If you want total security, go to prison. There you're fed, clothed, given medical care and so on. The only thing lacking... is freedom. ” ― Dwight D. Eisenhower