View Single Post
Old 03-22-19, 09:48 AM   #26
pinballlooking
Super Moderator
 
pinballlooking's Avatar
 
Join Date: Jun 2013
Location: SC
Posts: 2,767
Thanks: 162
Thanked 531 Times in 435 Posts
Default

I made a backhoe lift attachment.
It was made out of plate. My quick attach works so well that it is only one pin to switch. This should be useful for some jobs.




I also have a weld on lifting hook that I will weld on my 10” factory bucket.



I am going to make a smaller bucket for digging gutter drainage ditches.

I changes the bucket style I made similar to your 6 bucket. It is long and only 6 wide.
I made it longer because it really only digs the length of the bucket and a little more.
The backhoe is wider than the bucket where the thumb connects.



I thinking about making a Bxpanded style teeth for this bucket.


I painted my lifting attachment. This one is finished.


More progress on my new 6" bucket.
Attached Images
      
__________________
Current project Aquaponics system , Passive Solar Greenhouse build

To view links or images in signatures your post count must be 0 or greater. You currently have 0 posts.

Solar Install 12.5 Kwh-
To view links or images in signatures your post count must be 0 or greater. You currently have 0 posts.

Mini Split installs -
To view links or images in signatures your post count must be 0 or greater. You currently have 0 posts.

EV Chevy Volt -
To view links or images in signatures your post count must be 0 or greater. You currently have 0 posts.

Last edited by pinballlooking; 03-26-19 at 05:28 PM..
pinballlooking is offline   Reply With Quote
The Following User Says Thank You to pinballlooking For This Useful Post:
Daox (03-27-19)