View Single Post
Old 07-30-21, 07:57 AM   #8
pinballlooking
Super Moderator
 
pinballlooking's Avatar
 
Join Date: Jun 2013
Location: SC
Posts: 2,923
Thanks: 172
Thanked 564 Times in 463 Posts
Default

Two nights I got some time to test it out. I connected my Grinders VFD with my wires. It was running quite but when you tried to use the auto feed it would overload the VFD.
Last night I oiled the quill an got it to move good manually the tried the automatic feed and it worked well.
I tried forward reverse high an low range. Variable speed the three quill auto feed speeds. Everything works.

It has a one pump oil system I need to check out. I think some of the plumbing is crushed not sure it pump works.

I tested the 3 phase 2 hp grinder started right up.
Very happy so far. It is still on the trailer. I will need to rotate the head to get it in the grange. It is to tall on the trailer. I have a 8' door but it is still to tall. I need to move stuff around to get to the car lift to get it off trailer.

I am thinking about building a lowrider stand for it on casters to be able to move it around.

Here is a nice design that someone else made.






I bought some steel castors for it.
Attached Images
   
__________________
Current project Aquaponics system , Passive Solar Greenhouse build

To view links or images in signatures your post count must be 0 or greater. You currently have 0 posts.

Solar Install 12.5 Kwh-
To view links or images in signatures your post count must be 0 or greater. You currently have 0 posts.

Mini Split installs -
To view links or images in signatures your post count must be 0 or greater. You currently have 0 posts.

EV Chevy Volt -
To view links or images in signatures your post count must be 0 or greater. You currently have 0 posts.

Last edited by pinballlooking; 07-30-21 at 10:20 AM..
pinballlooking is offline   Reply With Quote
The Following User Says Thank You to pinballlooking For This Useful Post:
Daox (07-30-21)